Good day,

I am using Zabbix to get SNMP data from our Checkpoint firewalls, and need a bit of a push in terms of understanding how the data is returned.

I have a 4600 and when I consult the CP_SNMP_BestPracticesGuide PDF I am led to believe that in order to get a number representing the bytes in and out of a systems interface, I use the following command :

snmpwalk -c zabbix_ro -v 2c 10.20.20.251 1.3.6.1.4.1.2620.1.1.25.5.1.7

However, the data that is returned is :

[root@zabbix ~]# snmpwalk -c zabbix_ro -v 2c 10.20.20.251 1.3.6.1.4.1.2620.1.1.25.5.1.7
SNMPv2-SMI::enterprises.2620.1.1.25.5.1.7.2.0 = Counter32: 4255883716
SNMPv2-SMI::enterprises.2620.1.1.25.5.1.7.3.0 = Counter32: 693667791
SNMPv2-SMI::enterprises.2620.1.1.25.5.1.7.4.0 = Counter32: 0
SNMPv2-SMI::enterprises.2620.1.1.25.5.1.7.5.0 = Counter32: 0
SNMPv2-SMI::enterprises.2620.1.1.25.5.1.7.6.0 = Counter32: 2183142795

Can someone please tell me which number is the correct number representing the data I want.
Also, if the device has 4 interfaces, is one line of the returned data related to that interface, eg Mgmt, while another result is for say eth1, eth2 etc?

Thank you for any assistance you may provide.

Regards
Chris