CPUG: The Check Point User Group

Resources for the Check Point Community, by the Check Point Community.


Tim Hall has done it again! He has just released the 2nd edition of "Max Power".
Rather than get into details here, I urge you to check out this announcement post.
It's a massive upgrade, and well worth checking out. -E

 

Results 1 to 3 of 3

Thread: Installing R77.30_T204

  1. #1
    Join Date
    2018-12-12
    Posts
    1
    Rep Power
    0

    Default Installing R77.30_T204

    Hi

    I am new around to Check Point and am trying to install the Check_Point_R77.30_T204_Install_and_Upgrade.tgz package to a 5600 that has now running R77.30 build 001

    For some reason after I installed that package, it broke show asset all and show sysenv in that there are no displays for the later and only CPU frequency and platform is show for the former

    Any ideas what is causing this ?

    Thanks

    HK

  2. #2
    Join Date
    2008-07-31
    Location
    Netherlands, Europe
    Posts
    1,146
    Rep Power
    12

    Default Re: Installing R77.30_T204

    The T204 package is old and not suitable anymore to be installed on any device, one of the reasons being that it still uses a cert that will be generated in the future past the Epoch date, therefore is not valid.
    you better revert to the old factory image on the 5600 as far as I know it does not support the 5000 series.
    Regards, Maarten.
    Triple MDS on R77.30, MDS on R80.10, VSX, GAIA.

  3. #3
    Join Date
    2007-06-04
    Posts
    3,299
    Rep Power
    17

    Default Re: Installing R77.30_T204

    https://supportcenter.checkpoint.com...40&from=wizard

    Is where the New Installation / Upgrade Wizard takes through too.

    Just personally had too many strange issues with the image that shipped on units in the past. Sure it is probably fixed now but old habits die hard and tend to just use the wizard and do a clean build with what the image says to use.

Similar Threads

  1. Installing R77.20
    By rdk672073 in forum R77
    Replies: 7
    Last Post: 2014-10-06, 13:48
  2. new to installing
    By kidem in forum Installing And Upgrading
    Replies: 15
    Last Post: 2008-10-16, 12:29
  3. Installing ClusterXL - HA NGX R62
    By abxjava in forum Clustering (Security Gateway HA and ClusterXL)
    Replies: 0
    Last Post: 2008-05-30, 04:47
  4. Installing a CLM
    By mcarey in forum Installing And Upgrading
    Replies: 0
    Last Post: 2007-09-05, 12:08
  5. Installing on 2003 R2
    By Mr_Lien in forum Installing And Upgrading
    Replies: 7
    Last Post: 2006-09-15, 11:35

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •