GAIA R77.30 with JHFA 205 clusterXL High Availability.
1st sync is crossover interface between gw1 and gw2,
2nd sync is an interface connected to a single switch from one of gw1 and gw2 interfaces. Same VLAN ofcourse.
under normal state, gw1 is active and gw2 is standby.
Now if I go into the switch and perform a "shutdown" on the switch port that the 2nd sync interface connected to gw1. Now "cphaprob state" on gw1 is shown as down. gw2 is now active
Is that normal?
I thought the purpose of 1st sync and 2nd sync is to provide redundancy and not for something like this happen.