CPUG: The Check Point User Group

Resources for the Check Point Community, by the Check Point Community.


Tim Hall has done it again! He has just released the 2nd edition of "Max Power".
Rather than get into details here, I urge you to check out this announcement post.
It's a massive upgrade, and well worth checking out. -E

 

Results 1 to 2 of 2

Thread: Please help me to understand UTM

  1. #1
    Join Date
    2009-10-15
    Posts
    19
    Rep Power
    0

    Default Please help me to understand UTM

    I currently have an old Nokia IP530 HA cluster which I need to upgrade to a new R70 system

    Initially I wanted to replace them with Power-1 5075's, but I can't really justify the cost. My question is, can I run the following blades on a UTM-1 2073?...

    - Firewall blade
    - VPN blade
    - Advanced Networking blade for QoS
    - Acceleration & Clustering blade for SecureXL, CoreXL, ClusterXL

    Other than the obvious hardware differences, can a UTM system do everything a Power-1 can do in terms of functionality? i.e. state table clustering etc?

    Thanks

  2. #2
    Join Date
    2007-07-16
    Location
    a land down under!
    Posts
    2,015
    Rep Power
    14

    Default Re: Please help me to understand UTM

    In short, yes. Based on the technologies you've listed, there's no dramas with using a UTM-1 box for that. IPS blade is probably the one where a Power series may make a difference, because of the multicore nonsense... otherwise, the rest should fit fine.

Similar Threads

  1. A little error I don't understand !!!
    By ducnv in forum Authentication
    Replies: 2
    Last Post: 2009-04-06, 10:42
  2. Help me understand how NAT and VPN tunnels work with each other
    By hammop1 in forum IPsec VPN Blade (Virtual Private Networks)
    Replies: 0
    Last Post: 2008-04-24, 11:05

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •