Search:

Resolved :-).

Status before:
backup firmware - 7x.x.xxx
Main firmware - 8.2.55x
Speed only 10Mbps

Status after:
Backup firmware - 8.2.55x
Main firmware - 8.2.55x

Thanks guys for advice,

firmware 8.2.55 restored - no change, speed is still 7-10Mbps
direct connection end station to Edge via Ethernet - same situation speed is still 7-10Mbps

Direct connect...

Guys,

I have problem. My Edge W 8.2.59 is directly connected via Edge WAN port into VDSL modem. Internet ISP line have speed 20 Mbps. But speed on end station connected via WiFi from Edge is only...

Hi Costyn,

You need do check SIC, management certificate or ICA status via SSH.

Best regards

Hi Moojay,

Please, check license for URL filtering.
Check rule base, check DNS resolving, check global properties - Accept outgoing packet originating from gw, try experiment with this settings....

Hi,

You can try debug problems via cmd.

Log in via ssh to your fw and run this command in expert mode:

avsu_client

After this you will see this:

So, resolved 2 months ago.
I forgot write solution.
For standard connection on port 443 TCP is necessary follow document CP_NGX_R65.4_(HFA40)_Endpoint_Connect_AdminGuide. And connection will be ok....

Thanks guys for responses. I try it. Thanks

HI all,

My customer have on client PC Windows Vista 64-bit. I need create VPN access to internal lan behind UTM-1 450 R65 HFA-04.
I have manual Check Point Endpoint Connect NGX R65.4 (HFA40).
...

Problem was resolved.
Simply :-)), I installed HFA-03 and libsw 7.5.56.

Thanks for ideas.

Yes thanks, I thought it. Supports HFA-02 - libsw 7.5.56?

Thanks

Hello all,

I have problem with update Edge signatures for antivirus.
Edge X firmware 7.5.56 is centraly managed. When I do update on UTM-1 HFA-02(Smart Center), I see this:
VPN-1 UTM Edge...

Hi all,

IKE phase 1 failed between CheckPoint R65 and Cisco ASA.
In VPN logs I see :5th packet = notification: malformed-payload. Phase 1 is not completed.
PSK and VPN, timing, configuration are...

Today I´m passed CCSE+ 83%.

90 questions 120 minutes.

98% knowledge is in ATRG NGX and official courseware Check Point Security Administration NGX III.

Hi Sebastan,

Yes, use this tool for editing "supernet".
Use steps from melipla.
And be careful, whith GuiDBEdit you can change global behavior FW-1!

Best regards
David

Hi Sebastan,

Default path on your PC where you have installed Smartconsole: GuiDBEdit.exe
file is installed in the C: \Program Files\CheckPoint \SmartConsole\R65\PROGRAM
directory with the...

Hi Conny,

Once you verify IKE packets arrive at both sides, run a debug for IKE traffic
with the "vpn debug ikeon" command.

On Checkpoint side:
vpn debug ikeon - turn on debug
vpn debug...

Hi,

Can you try use Web Visualization Tool

Check Point Software: NGX Utilities

Yes, only R55 and lower version, but you can check this procedure for this products and components:VPN-1 Pro/Express NGX R60
VPN-1/FireWall-1 NG with AI R55 HFA_14 and higher ,VPN-1 VSX NGX R60, ...

Hi.



Unix/Linux:
-------------
1) Run "cpstop".
2) Edit "$FWDIR/conf/discntd.if" with the names of the disconnected interfaces.

NOTE: