Applying policy blocks all access

[gfgkemp]

Hi,

I've just changed the external IP address on a Nokia IP350. When this was done I had to unload the policy to connect to the SmartDashboard on R62. Once connected I apply the updated policy however this causes all access to the be blocked.

Does anyone have any ideas what could cause this?

Graham

[Danielpb]

Whats sort of loging are you seeing ...if any?

As you can pushed a policy you must have updated the checkpoint object in the firewall rulebase?

you could also check the Nokia System message logs.

[mcnallym]

Did you change the Topology definition for the Check Point object, as well as the NAT address for any Public Servers.

I am assuming that changed the subnet rather then change the IP address to another in the same subnet.

[gfgkemp]

I changed the Interface IP address & subnet through the Nokia Voyager the original IP was in the 158.x.x.x range and the new IP is in the 62.x.x.x range.

I also updated the Check Point object and the topology as well.

Unfortunately, I don't have a record of any logs as it was pretty urgent to get the box up and running so we had to rebuild from scratch.