Missing CA menu on Cpconfig environment

[motociclante]

Hi,

I'm trying to configure my NGX-R60 for the very fist time and, following the official documentation I'm experiencing some problem.

When the pdf write about the Certification Authority it refers to a spefici menu.

This is the menu I have.



I think that I'm missing something but I don't know what.

Could someone please help me?

Thanks
MotoCiclante.

[Joncon]

I this just a management station (smartcenter) or combined management and enforcement module (gateway)?

[Joncon]

Or is it just an enfoercement module (gateway)?

The type of installation will affect what is availible / shown in CPCONFIG.

[kva.kva]

And did you create ICA at installation step?

[motociclante]

Originally Posted by Joncon

I this just a management station (smartcenter) or combined management and enforcement module (gateway)?

Thank Joncon.
It's just a management station for DR purpose. In cais of fail of the primary management, this would be the backup one.

[motociclante]

Originally Posted by kva.kva

And did you create ICA at installation step?

Thanks kva.kva.

No, I haven't create the ICA because I think that, installing SPLAT as a secondary management statio, this procedure was automatically been jumped.

MotoCiclante

[Joncon]

If the ICA wasn't created I don't think you will see the CA menu on CPCONFIG.

See the Checkpoint_R61_Smartcenter_Userguide.pdf P262 for detailed instructions of how to create a secondary smartcenter from scratch. There is loads of good info in this doc including info on initial synchs between the smartcenters.

hth