SecuRemote blocks HTTPS under certain conditions?

[stachr]

I have SecuRemote NGX R60 HFA-02 installed on a XP SP2 laptop. When SecuRemote is bound to the LAN adapter and connected to our private network (10.0.0.0/16), I can access HTTP sites, but not sites that use HTTPS. If I unbind SecuRemote from the LAN adapter, HTTPS websites work fine. The SecuRemote services are set to start automatically.

If I disconnect from the private network and connect to a wired network on a different subnet, i.e. 192.168.x, HTTPS sites work fine.

Am confused!! Any ideas for a Check Point VPN luddite like me? :-)

<edit>
I've also noticed around the same time I submit the HTTPS request, i.e. from within MSIE6, an "FW1" error is logged in the System event log. Full details below:

Event Type: Error
Event Source: FW1
Event Category: None
Event ID: 1
Date: 31/10/2007
Time: 16:58:23
User: N/A
Computer: <computername>
Description:
FW1: F Sending reset dire

Unfortunately this event means absolutely nothing to me!!
</edit>

[mcnallym]

Is the SecureClient configured to support Visitor Mode at all as that uses HTTPS to encapsulate the normal VPN traffic.

[stefan73er]

hi,

i had similar problem with the access to https sites if the SR is bound to the LAN interface.

this reg entry solve it for me

Windows Registry Editor Version 5.00

[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Servic es\FW1\Parameters\Globals]
"asm_http_allow_connect"=dword:0000000e


I hope it will help you too.

cheers,

Stefan