sk30402 - NGX - Dynamic resolving mechanism

[arbi.arbi]

Hello,
Whould you please help me with this?
The network from which the SecureClient has to connect uses the same IP-address range as my internal network (intended destination). I have to "push" the client to consider VPN topology prior to standard routing decision.

SecureKnowledge article sk30402 describes the solution for NG AI.
In short: configure Global policy properties to use Dynamic resolving mechanism. Then edit Gateway VPN properties to allow dynamic-resolution. Install the policy and update site on the client.

But I have to configure it on NGX R65 where such parameters are not present ...

Thanks a lot
Regards
Robin

[melipla]

Originally Posted by arbi.arbi

The network from which the SecureClient has to connect uses the same IP-address range as my internal network (intended destination).

Changing the dynamic resolution method won't help. You need to use Office Mode to enable communication between SecureClient and your internal network.

See #sk30545 and #sk30547. There's also good documents regarding SecureClient and Office Mode found in the documentation section of Check Point's website.

[arbi.arbi]

thanks a lot Melipla! I'm the begginer in Check Point. Have a lovely day!!
Robin