Troubles Installing SecuRemote on Win9x

[BarryStiefel]

Troubles Installing SecuRemote on Win9x



After Installing SecuRemote, one of the following errors occur:

1. TCP/IP does not appear to function
2. There are errors in connecting to my ISP via Dial-up Networking (it works with SecuRemote disabled)
3. On boot, you get the error message "At least one adaptor did not bind correctly. It may be necessary to reboot." I did this, but I still keep getting this error

Two things may solve this problem:

• Reinstalling the TCP/IP stack
• Changing bindings on the TCP/IP stack

Reinstalling the TCP/IP Stack

1. Delete all network adaptors, protocols, and bindings from the Network Control Panel. Do not uninstall SecuRemote. Reboot as prompted.
2. Re-install the Dial-Up Adapter, NIC (if needed) TCP/IP, and Client for Microsoft Networking, and anything else you need to install, including PPPoE clients. It is not necessary to install IPX/SPX or NetBEUI on a dialup adaptor unless they are used by your ISP. Reboot when prompted.
3. Re-install SecuRemote, upgrading existing installation. Bind to your adaptors as necessary. Reboot as prompted.

Chaging Binding on the TCP/IP Stack In cases where the above didn't work, try this:

Go to the Network Control Panel, click on FW1 Protocol. Check the appropriate interfaces (where SecuRemote will be installed) and reboot.

-- PhoneBoy - 10 Apr 2004

FAQForm FAQs.Class: SecureClientFAQs, TroubleshootingFAQs FAQs.OS: FAQs.Version: