100% CPU after policy install

K.H. Cheung · #1 (**permalink**) 2006-02-01

Dear all,

I installed policy on a CheckPoint firewall cluster (2 servers with SPlat
R55 HFA12). Afterwards, the CPU of one firewall jumped from about 20%
to 100% and did not fall back even after a few hours. Eventually, I
needed to reboot the firewall to make it normal again.

One day later, my another firewall in the same cluster got the same
problem as well. This time I didn't do any policy installation.

In both cases, no processes were shown to be CPU-intensive when
I ran the "top" commands.

Did anyone face the same problem before or know any solution? Thanks
a lot.

K.H. Cheung

kva.kva · #2 (**permalink**) 2006-02-01

Check Release Notes for last HFA, some problems with high processor loading was resolved in it. May be some of them resolve your problem.

How do you monitor CPU loading?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode