ISP Redundancy issues

[paul3105]

Good day everyone!

I have recently upgrade from R55 to R60 and i checked the ISP redundancy if still working. Yes it is still working but when you filter the xlatesrc to check whether if it's utilizing both links, I only see it uses only one link literally for all connections. It doesn't change or distribute to the other link. My setting is ISP load sharing therefore the firewall will evenly distribute the outbound connections evenly but it isn't. Both ISP is up and working and back from R55 it is working. I've also included to the settings the hosts that it will send icmp requests to check whether the links is up/down still it doesn't distribute. Are there are any advance settings or other configurations to manually distribute or any R60 issues regarding ISP redundancy???

A response is greatly appreciated, thanks!

[chandruenn]

Hi Paul3105,

I am trying to configure ISP Redundancy with One Leased Line and other one is DSL Link. When i say ok after configuring the ISP Redundancy i am getting an error saying that

"At least one of your ISP Links lack a next hop IP Address configuration.

Not: next hop IP Address is also used to automatically monitor the ISP Link's availability.

Are you sure you want to continue?"

Can you please guide how did u achieved the ISP Redundancy configurations.

[mcnallym]

Static NAT does only use 1 link even in Load Sharing, it is a documented issue and in the knowledgebase. Hide NAT should use both links if set to be Hide Behind Gateway so can use both IP addresses.

[chandruenn]

Hi,

I am facing the issues when i configure the ISP Redundancy support on the Smart Dashboards.

So, can you please guide how to acheieve this.

Chandru.

[mcnallym]

Where you define the interfaces used for ISP Redundancy there is also a section for both interfaces to add the next hop.

Make sure you fill this in for both.