NOKIA IP330 Initial configuration

[betski]

I've picked up an old Nokia IP330 from one of my other offices. I don't know the admin password or any of the interface IP addresses.

I've managed to reset the admin password in single user mode but when i use 'ifconfig-a' none of the interfaces have ip addresses so i cant connect via voyager to make the password permanent. is there a way to configure the interfaces with the CLI or even easier, a way to run the factory startup wizard ???

[abusharif]

yes it is, use clish (see ipso CLI reference guide)

[Danielpb]

I think depending on the version of IPSO you can use the command
lynx to access the voyager by telnet session.

[buulam]

I believe the command "install" will launch the factory setup? I think it has to be done in single user mode. Hope that helps...

I think I have the documentation if you want it, lemme know - buulam @ hotmail.com

[abusharif]

if u want to restart the config procedure (initial where u get asked for hostname ip etc) remove /config/initial file and restart the appliance, this will reset all settings.

[betski]

cheers for all the help guys. i'll give it a go later