routing at Checkpoint Provider-1

[mylove142]

Hi all,

I use Checkpoint VSX v2.5 that is installed at Crossbeam X40. At Crossbeam, I install Checkpoint VSX at 2 modules APM. I use Checkpoint Provider-1 to manage Checkpoint VSX.
Now, I have one question about the routing at Checkpoint VSX:
- When I add one route at Checkpoint Provider-1, I see the route can't apply at Checkpoint VSX installed at Crossbeam.

I want to know where I see the route applied in Checkpoint VSX at Crossbeam when I add route at Checkpoint Provider-1?

If you know, please answer me early. Thank you very much.

Duy Khang

[yogi_ccse]

The route should be added on enforcement module and not on provider-1/management centre/smart centre. I hope i've interpreted ur quesiton properly.

reg.
YT

[mcnallym]

You won't see the route on the crossbeam as the route assuming you are adding into the Virtual Router config within the Dashboard, is going into a virtual router.

As such the normal commands to check routes on the crossbeam don't show the routes as as such.

[mylove142]

I think that the route would be applied at enforcement module but I want to ask:

The route will be applied at which file of enforcement module?

If you know, please answer me early.

Regards,

Khang