Nokia IPSO losses dynamic routes

[pmpajaro]

Hello all, I am new at this forum. My problem is the following: I have one Checkpoint firewall installed in a Nokia IP appliance. I have an external DMZ where I connect the point-to-point links to my remote locations. I have a Cisco 2801 router to establish one of this point-to-point links. I have configured RIPv1 at the Nokia IPSO and at the Cisco 2801. I redistribute the static and dynamic routes from the Cisco to the Nokia (the Nokia interface is a passive interface for RIP). When I enable RIP at the two appliances, the Nokia learns the dynamic routes, but after a few time (1-2 minutes) this routes disappear.

I have configured the same scenario in our lab, and the Nokia hasn't lost the routes. What could has happened?

Best regards,

Patricia

[RedKnot]

You could try and configure the test lab Nokia exactly the same as the production one. And also the test lab Cisco as the production one and then get a 4 hr down time window and swap them around !

Drastic I know but you should soon know be able to narrow down the issue to a box.....