OSPF Configuration Commands

[brixo]

Hi all,

Planning ahead really...

My setup: Splat Pro + NGX R62 (Power-1)

I intend on attaching my CPFW to 2 seperate switches for fault tolerance - on the "inside" of the network.

I then need to run OSPF to advertise my "outside" networks into my "inside" devices.

As I will be running OSPF on both of my "inside" interfaces, i.e. one via switch1 and one via switch2, I need to be able to control which path traffic takes... from a Cisco point of view, I would add a higher "cost" to my backup interface to make it less preferred.

Can this be done within the routing module? Has anyone got any documents on configuration of OSPF within SplatPro?

thanks in advance.