Get Topolgy not pulling in all interfaces?

[GordonCopestake]

I have a SPLAT 2.6 / R65 / Cluster XL setup with 2 nodes. Each node has 3 NIC's eth0,eth1 & eth2. When I "get" the topology I only see eth0 & eth1 with eth2 being nowhere in sight. However if I try to add eth2 manually to the topolgy SmartCenter says that there is an interface with that name already exists.

If I detach each member from the cluster and get the topolgy the node can see all 3 interfaces, but when re-added to the cluster only 2 NIC's are shown. All 3 interfaces are shown in the SPLAT sysconfig menu system and all 3 NIC's are on the supported NIC list.

Anyone got any ideas how I can use this eth2?

Thanks in advance

[GordonCopestake]

Ah! Ignore me, noob mistake. I had eth1 and eth2 on the same subnet. Doh!