manual site-to-site vpn working with smartcenter it does not work

[kpatel]

Folks


I have a situation where I can make my edge box work if I do manual site-to-site VPN to my firewall at the other end. If I try to establish the tunnel with smartcenter it does not work. I can connect to smartcenter fine from VPN edge box but it does not create the tunnel. Any ideas?

[Izzio]

Which Edge firmware and smartcenter version are you using?
Is the "Enterprise" VPN-Tunnel present?

Normally you will find by "Reports -> Event log" informations about the Tunnel Key Exchange that can help you for troubleshooting.

Ciao - Maurizio

[ecolas]

Hi everyone,

Here is my config:
FW-1 R55 HFA17 SPLAT
VPN-1 Edge X

I had configured FW-1 to work with VPN-1 Edge and all was fine. But recently, i try to reconnect and problems appeared.
The tunnel is ok, all logs from VPN-1 Edge are posted in SmartViewTracker, but i can't communicate with LANs. My rule base is ok and I see that VPN-1 Edge encrypt packets but FW-1 never decrypt.
I have securemote users that can connect and for them it works fine.
I did a new time all the config for VPN-1 Edge and FW-1 (community, rule base, encryption) but LANs are always invisible.

Anybody have a suggestion.