[Tetaworx]

Hi,

we're using NGX (R60_HFA03).

Outgoing Route Selection is on "Operating system routing table", Source IP address settings is on "Automatic (derived from method of IP selection by remote peer)".

We need this setting, because some of our remote-users connect to an "internal" interface of our firewall, so we can't set this "hard" to "Manual: Main IP address".

Nevertheless the "Source Adress" of our IKE-pakets is correct, the external IP of our gateway. But the "ID" in the payload of the IPSec-pakets is the wrong one, the internal IP.

I don't see any option to manipulate this "ID" itself.

Further hints?

Thanks!