Sorry for the delay.
I suggest you to ask for the support, as they have an R61 development ISO which works (build 602000136).
They also gave me a link to a R60 ISO (build 591604034), I didn't test it either.
The modules mptbase.o and mptscsih.o installed on disk are revision 2.05.16.01, corresponding to bootdisk modules.
They ask me the log in debug mode :
Code:
Kdb Mode NGX
On the Gateway run:
# ulimit -a (to see if the core file blocksize is limited)
If it is limited issue:
# ulimit -c unlimited (this should enable the creation of the hole memory
dump to a file)
In order to start the machine in Kernel Dbug mode:
First of all, we need to change the grub.conf file (under /etc/grub.conf)
on the crashing SecurePlatform according to our configuration. If you'll
open the grub.conf you'll see all the Kernel startup options. The one that
interests us is this one:
title Start in debug mode
root (hd0,0)
kernel /vmlinuz-smp_kdb ro root=/dev/sda3 console=CURRENT 3
initrd /initrd-smp_kdb
The CURRENT should be changed to ttyS0 if we connect the crossed cable
from COM1 on the crashing machine, and ttyS1 if the we connect to COM2.
Before changing the grub.conf, please backup it. Reboot the machine and
follow this procedure:
1. Connect a seperate machine to one of the cluster members using Serial
cable to COM 1
2. From the seperate machine please connect to the machine (use serial
application like CRT for example). The connection parameters are the RS232
default (9600, NONE, 8, 1, NONE).
3. Even without the crash, we should be able to communicate with the
crashing machine through the COM port. Make sure you have a Serial
connection with the machine and that you can run commands (the syntax is
like in telnet
4. Reboot the SecurePlatform and start in [Debugging] mode.
5. Make sure your serial connection is still working and that you can run
commands through.
6. Now we need to wait till the freeze occurs.
7. When the freeze occurs please type on the serial console machine the
command "bt" or "bta" (bt should be tried first), this will get the
required stack from the freeze.
8. In case the keyboard are not responding use CTRL+C or CTRL+A or send a
break signal from the Serial application and then try the "bt" command
again.
9. Save the "bt" output and make sure we get all the stack
10. Reboot the module.
11. After changing grub.conf to the original version, reboot is must in
order to get out from the debug mode.
12. Please send me the file.