Quote:
| Originally Posted by chillyjim Lets start with what version of Check Point are you running?
What HFA if any are installed?
What version of Solaris? |
I'm using Check Point NG AI (R55) HFA 17, Hotfix 670 - build 004 and for SmartCenter server is running on Windows XP, Version 5.1, OS Build 2600.
Meanwhile, my three enforcement servers are running on NG AI (R55) HFA 17, Hotfix 670 - Build 004 (Build 541670004) with Solaris 5.9 (Solaris 9) with latest patches. All of it using SUN 1GB Quadcard.
I'm using 3rd party load-balance/High Availability - RainFinity RainWall 3.1 SP5 R1.
Attached is the diagram of my firewall set up. Noted that the diagram showed only the 'heartbeat' part of firewall clusters. The rest of the interface of 1GB quadcard of each enforcement servers are connected to a different (separate) VLANs but going through the same Cisco 6509 switches. These switches are using CatOS software. I noticed that this particular command " set cam static [multicast mac address] module/port" is not available in our switch. What I did is to set the VLANs with no configuration set on it except the no igmp snooping command.
Please advice. Thanks very very much.
Regards,
Al