Quote:
| Originally Posted by FERappel W/ native IOS, you should follow the "Example Configuration of Cisco Catalyst 6xxx" (idem & idem). |
Both 6500 series routing switches are using CatOS instead of native IOS.
Quote:
| Originally Posted by Chillyjim Short answer the firewall interfaces need to be real/not-vlan interfaces. The switch side of the connection can cross switches via a trunk port. |
Our SUN 1GB Quadcard does not have any VLANs configured.
Quote:
| Originally Posted by Chillyjim Longer answer -- Make sure the trunk has enough bandwidth to handle the sync traffic (I've seen over 800 Mbps on a sync connection). You also have to worry about latency. If it's all "local" fiber you should be OK, but leased fiber from a carrier is as likely as not, not to work. |
Yeap.. we using "local" fiber which connects both 6500 series at different locations.
By the way, I had performed sync between these enforcement by rebooting all of it in one go. I noticed during bootup, it able to sync with other enforcements but when I checked with cphoprob state command. Every enforcements seeing each other as down state. I have no idea about this already. I'm almost managed to get these works. Kindly advice.
Thanks.
Al