[baboo]

Hi Maurox

I think we're having the same problem.
During the fail-over to the standby-node there's an interrupt of 73 seconds.

If we trigger a failover (cpstop on active-node(gate3) ) the fail-over succed (to gate4), but the sync-interface on the node that became active (gate4) goes to "down". Which results in a topology change I think.
If we do that the other way (cpstop on the active-node gate4 to fail-over to gate3) the state of the sync-interface keeps "up".

I dont know if this is just related to the standby-clustering or also to the load-sharing. Can you verify this ?

We're also having troubles with the policy-installation. (see the other thread)
Do you also have problems with the policy-installation?

Regards, Manuel