[pop_alex]

Hi there,

I read about State Synchronization in ClusterXL document saying that

"There are two restrictions to the synchronization network:
First, VLANs cannot be used in the synchronization network in any version. Second, in older versions, the interface used for the synchronization network must be a real interface with a real IP address (as opposed to a cluster IP or a virtual IP)." page 15.

I have two Cisco Catalyst 6500 series which is connected each other fibre (trunk together) and our firewall are connected to it on both side through dedicated VLAN two on location A and one in location B).

My question is does it really works? Anybody had done a state sync across two routing switches before? If yes, can someone kindly give me a guide about this?

Thanks very much.

Regards,

Al.