View Single Post
  #3 (permalink)  
Old 2008-05-29
vijayant vijayant is offline
Senior Member
 
Join Date: 2006-05-24
Location: India
Posts: 151
Rep Power: 3
vijayant has an average reputation (10+)
Default Re: Change SIC Interface

Daniel

Can you please explain why do you have these doughts.. I am not sure how the SIC was establish but I will proceed with steps told by you. Please let me know if any more info i can give to you to diagnose on this.

eth0 Link encap:Ethernet HWaddr 00:07:E9:0D:58:68
inet addr:10.0.0.1 Bcast:10.0.0.3 Mask:255.255.255.252
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:199837285 errors:0 dropped:0 overruns:0 frame:0
TX packets:312201896 errors:0 dropped:0 overruns:0 carrier:0
collisions:30 txqueuelen:100
RX bytes:2517148034 (2400.5 Mb) TX bytes:3606523651 (3439.4 Mb)
Base address:0xecc0 Memory:dfbe0000-dfc00000

[Expert@SUN]# ping 10.0.0.2
PING 10.0.0.2 (10.0.0.2) 56(84) bytes of data.
64 bytes from 10.0.0.2: icmp_seq=3 ttl=128 time=11790 ms
64 bytes from 10.0.0.2: icmp_seq=5 ttl=128 time=12010 ms
64 bytes from 10.0.0.2: icmp_seq=7 ttl=128 time=12487 ms

Some times I am getting:
#cphaprob state
1 (local) 203.17.26.4 100% active attention
2 203.17.26.5 0% down

in general i do not see any traffic on the sync interface

this is a remote location for us. I do get disconnected when i am working on Smart center server that is located on the internal network of this firewall.

Thanks
Reply With Quote