 VSX R60 SPLAT Cluster Failure
Yesterday I had a total failure of a two node cluster using SPLAT. It appeared that after the first member crashed the standby followed within one minute. Cluster is VSX R60 HFA01 and is hot-standby only. Total of 8 customer VS's totaling about 4000 users.
The cluster required a power cycle to recover, the console was blank screen no response from keyboard. These are Dell 2850 with Intel Pro1000 Quad Card. Using the on-board Intel nics for sync and mgt. Layer 3 only, no bridging. The only thing I've found so far is a log message stating the cluster is under high-load and will stop logging to the CLM.
Looks like the largest customer was pushing 15k connections steady and the bandwidth throughput was less then 300 mbps. Check Point hasn't said much yet, has anyone seen anything like this using SPLAT and VSX? |