[humayun]

I dont know what I am doing wrong here. Its an IP 260, running IPSO 4.1 so I have to use clish... Hate it. I definitely miss lynx.

Can someone please point out what I am doing wrong here trying to set the interface? Thanks.

fw01[admin]# ifconfig -a
loop0c0: lname loop0c0 flags=57<UP,PHYS_AVAIL,LINK_AVAIL,LOOPBACK,MULTICA ST>
inet6 mtu 63000 ::1 --> ::1
inet mtu 63000 127.0.0.1 --> 127.0.0.1
phys loop0 flags=10b<UP,LINK,LOOPBACK,PRESENT>
pppoe0: flags=127<UP,LINK,POINTOPOINT,MULTICAST,PRESENT> encaps none
soverf0: flags=2923<UP,LINK,MULTICAST,PRESENT,IPV6ONLY>
stof0: flags=2903<UP,LINK,PRESENT,IPV6ONLY>
tun0: flags=107<UP,LINK,POINTOPOINT,PRESENT>
eth1: flags=4132<UP,BROADCAST,MULTICAST,PRESENT>
ether 0:a0:8e:9a:53:73 speed 10M half duplex
eth2: flags=4133<UP,LINK,BROADCAST,MULTICAST,PRESENT>
ether 0:a0:8e:9a:53:74 speed 10M half duplex
eth3: flags=4133<UP,LINK,BROADCAST,MULTICAST,PRESENT>
ether 0:a0:8e:9a:53:75 speed 100M full duplex
eth4: flags=4132<UP,BROADCAST,MULTICAST,PRESENT>
ether 0:a0:8e:9a:53:76 speed 10M half duplex


fw01[admin]# clish
NokiaIP260:26> set interface eth3 speed 100M duplex full active on
NokiaIP260:27> set interface eth3 address 192.168.1.2/24 enable
CLINFR0329 Invalid command.
NokiaIP260:28> set interface eth3c0 address 192.168.1.2/24 enable
CLINFR0329 Invalid command.

I need this info asap please, as I cant progess beyond this.
Thanks.